Table of Contents
Advertisement
30/48
Press module Type IH04E | Commissioning
General information
Bosch Rexroth AG, Edition 09.2022, RE 63129-MON
Uncontrolled connection or disconnection of electrical component plug-in
connectors!
Damage to property!
▶ Before installation works, separate the press module type IH04E from
the mains or from the voltage source or de-energize it.
▶ Do not plug in or pull off the electric plug-in connector as long as the
voltage supply is activated.
Wear and malfunctions caused by contaminated hydraulic fluid!
Damage to property!
▶ During commissioning, absolute cleanliness must be ensured.
▶ Make sure that the hydraulic system is only filled with a filtered hydraulic fluid.
▶ Ensure that no contaminations are able to penetrate when sealing the ports.
For commissioning of the press module type IH04E, always observe the
operating instructions of the overall machinery/system.
▶ Ensure that changes to the safety-relevant valves/nozzles, see chapter 5.2
"Description of safety-relevant components", are only made by accordingly
qualified and experienced specialists and after consultation with the
manufacturer.
▶ Ensure that nozzles are not changed after initial commissioning.
▶ Ensure that safety-relevant components, see chapter 5.2 "Description of
safety-relevant components" are only replaced by valves of the same type.
For further information on replacing valves, see chapter 10.7 of the general
operating instructions 63124-B, see chapter 1.2 "Required and additional
documentation"
▶ Ensure that safety-relevant components, see chapter 5.2 "Description of
safety-relevant components", are replaced before the specified period of use
is exceeded, because the required reliability of the components is no longer
guaranteed when these limits are exceeded and the performance level of the
safety functions is no longer valid; in this case there is an increased probability
of a dangerous failure.
For further information on the period of use of the components, refer to the
associated data sheets, and on calculating the probability of a dangerous
failure refer to data sheet 08012, for reliability characteristics MTTFD for
functional safety according to EN ISO 13849, see chapter 1.2 "Required and
additional documentation".
NOTICE
Advertisement
Table of Contents
