Product- And Technology-Dependent Safety Instructions - Bosch rexroth IH04E Assembly Instructions Manual

12/48 Press module Type IH04E | Safety instructions
Bosch Rexroth AG, Edition 09.2022, RE 63129-MON
The installation of the press module type IH04E is only admissible if a leakage
velocity of 5 mm/s is not exceeded when opening the measuring port on
the load-supporting side.
For hydraulic presses according to EN ISO 16092-3 and use of a PLC for valve
monitoring, the PLC must meet the specification profile (such as SRP/CS)
according to EN ISO 13849-1 PL "e" (category 4).
For maintenance and repair, the user must additionally ensure a mechanical
restraint device between the tools, see EN ISO 16092, 5.3.6 and/or EN 289,
5.4.1.1.3.
For hydraulic presses according to EN 289 with a depth of the clamping plate
greater than 800 mm and stroke greater than 500 mm, a mechanical restraint
device according to EN 289, 5.4.1.1.3. is required.
2�6 Product- and technology-dependent safety instructions
The following safety instructions apply to chapters 6 to 9.
Uncontrolled moving parts due to incorrect control and unexpected start-up
when safety functions are bypassed or functional safety is not observed!
Danger to life! Risk of injury! Danger of entanglement, ejection or crushing
of persons!
▶ Note the requirements of EN ISO 13849 as well as the relevant product
standards EN ISO 16092 and EN 289 when setting up functional safety.
▶ Mount EMERGENCY stop devices, a safety door, light barriers,
light curtains and/or two-hand control device.
▶ Immediately replace defective safety-related components.
Leakage of (pressurized) hydraulic fluid and oil mist!
Danger to life! Risk of injury! Explosion hazard, risk of fire, health hazard,
environmental pollution! Damage to property!
▶ Switch the machine/system off immediately (emergency off switch).
▶ Identify and remedy the leakage.
▶ Never try to stop or seal the leakage or the oil jet using a cloth.
▶ Avoid direct contact with the leaking hydraulic fluid.
▶ Use your personal protective equipment, e. g safety goggles.
▶ Do not use the press module type IH04E in areas with open fire
(e.g. ignition sources ...) and only at a sufficient distance to hot heat sources.
▶ When dealing with hydraulic fluids, you must implicitly observe
the information of the hydraulic fluid manufacturer.
WARNING