Table of Contents
Advertisement
System design and installation | Press module Type IH04E
6 System design and installation
Unintended downward movement due to oil loss through measuring point MX1,
MX1�1!
Danger to life! Risk of injury!
▶ Stay away from the danger zone if a hose or the like is attached to measuring
point MX1, MX1.1.
▶ After using the measuring point MX1, MX1.1, carefully check that it is tightly
closed and that the protective cap is reassembled.
Unintended downward movement due to oil loss through cylinder seals,
valves and fittings!
Danger to life! Risk of injury!
▶ Ensure that the retraction of the cylinder in the standstill does not exceed
1 mm/s in normal operation and 5 mm/s in the event of component failure.
▶ Always keep the time spent in the danger zone as short as possible.
▶ Always use a mechanical restraint device for all work.
For information regarding the installation into the overall machine/system,
particularly regarding its overall function and logical mode of operation,
please refer to the operating instructions of the machine manufacturer.
For additional information on how to prepare and execute the installation,
refer to operating instructions 63124-B, see chapter 1.2 "Required and
additional documentation".
6�1 Installation conditions and position
▶ During installation, always observe the environmental conditions such as
the temperature range and operating parameters such as the hydraulic fluid,
filtration, voltage and operating pressure specified in data sheet 63129,
see chapter 1.2 "Required and additional documentation".
▶ It is imperative to provide for absolute cleanliness. Contamination of
the hydraulic fluid may considerably impair the life cycle of the hydraulic
component.
▶ Provide measures to prevent slipping on leaking hydraulic fluid,
e.g. non-slip floor, drip pan.
▶ Select the installation position according to your technical requirements.
– Overhead installation is excluded.
– Install the press module type IH04E horizontally and with the directional
valve .110 at the top.
– Select the installation position so that the installation, repair,
disassembly and adjustment of valves is possible without problems.
– Assemble the press module type IH04E as close to the cylinder as possible.
– Position or house the press module type IH04E in such a way that
hazards due to liquids spraying out under high pressure are avoided.
Ensure that the X1 line is as short as possible.
WARNING
RE 63129-MON, Edition 09.2022, Bosch Rexroth AG
23/48
Advertisement
Table of Contents
