Adapt Language Variants To Driver's Instructions - Skoda Octavia III 2013 Service Manual

– Hold button -3- pressed and at the same time turn on the ig‐
nition until the following message is displayed on the dash
panel insert display:
Reset oil change service?
or
DELETE OIL_CHANGE
– Release button -3- and press it again.
6.11 Adapt language variants to driver's in‐
structions
Adjust the language variant for vehicles without infotainment ra‐
dio/navigation
The language variants of the driver instructions are selected with
the vehicle diagnosis, measurement and information system -
VAS- .
– Connect up the vehicle diagnosis, measurement and informa‐
tion system -VAS- using the appropriate diagnostic cables
⇒ Vehicle diagnostic tester.
Connect the diagnostic unit to the diagnostic connector -1-.
– On the diagnostic device, select: "Targeted functions" → "Ško‐
da" → "Octavia 2013►" → "Engine type" and further → "Dash
panel insert" and further → "Code language variants for driver's
information system".
– Set the desired language taking account of the diagnostic unit
display.
Adjust the language variant for vehicles with infotainment radio/
navigation
The adjustment of the language variants for driver's instructions
takes place by changing the language in the infotainment radio/
navigation
Carry out the adjustment of the language variants of the driver's
instructions as per the vehicle specification.
The vehicles are equipped with different infotainment radio/navi‐
gation. For operation refer to the ⇒ operating instructions info‐
tainment radio/navigation .
– Switch on ignition.
– Select the following in the infotainment radio/navigation:
"Device settings" (button
SETUP
or
"Vehicle settings".
– Further select the button
– Then proceed by referring to the read-out on the display.
) and in addition button
MENU
.
language
Octavia III 2013 ➤ , Octavia III 2014 ➤
Maintenance - Edition 12.2014
137
6. Electrical System