Cooling System: Checking - Skoda Octavia III 2013 Service Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
Maintenance - Edition 12.2014
– Unscrew oil drain plug -1- from the screw cap -3- and drain the
engine oil out of the oil filter.
– Insert screw cap for oil filter -3- with socket insert SW 32 .
– Pull out filter insert -5-.
– Drain engine oil ⇒ page 47
Install new replacement oil filter element
– Insert a new O-ring -2- into the slot of the oil drain plug -1-.
– Screw the oil drain plug -1- into the cap -3- and tighten.
– Moisten new O-ring -4- with engine oil.
– Insert new oil filter element -5-.
– Screw in the cap -3- with the socket insert SW 32 and tighten
to tightening torque.
Tightening torque
Screw cap for oil filter:
Oil drain plug at cap
– Clip the generator cable -2- into the clip -3-.
– Insert the connector -1- for the trailing pump.
– After filling with oil, run engine until it is at operating tempera‐
ture and inspect for tightness.
– Install the noise insulation.
3.9

Cooling system: Checking

Inspecting antifreeze protection, replenishing coolant additive if
necessary
⇒ "3.9.1 Inspecting antifreeze protection, replenishing coolant
additive if necessary", page 56
Inspecting coolant level (volume)
⇒ "3.9.2 Inspecting coolant level (volume)", page 62
3.9.1 Inspecting antifreeze protection, replen‐
ishing coolant additive if necessary
Special tools and workshop equipment required
56
.
Nm
25
5