Check Oil Level In The Haldex Coupling - Skoda Octavia III 2013 Service Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
Maintenance - Edition 12.2014
Note
When the Haldex coupling is correctly filled, oil flows out at the
adapter -A-.
– Raise vehicle.
– Place oil reservoir under the Haldex coupling (e.g. trolley) so
that the excess oil flows back into the oil reservoir.
– If no more oil flows back, remove the filling device for Haldex
coupling - VAS 6291- .
• The Haldex coupling is now filled to lower edge of oil filler hole.

– Check oil level in the Haldex coupling

⇒ "4.4 Check oil level in the Haldex coupling", page 94
If the oil level is OK:
– Screw in oil filler plug -A- and tighten to tightening torque
⇒ page 95 .
4.4 Check oil level in the Haldex coupling
Special tools and workshop equipment required
♦ Catch pan - VAS 6208-
Test requirements
• The oil temperature must be between 20 and 40 °C. This oil
temperature can e.g. be reached by means of a test drive.
• Vehicle on level ground.
WARNING
Observe safety provisions and information during the test
drive.
– Read oil temperature⇒ Vehicle diagnostic tester
.
Functions
• The oil temperature must be between 20 and 40 °C.
94
4. Gearbox
.
Guided