Skoda Octavia III 2013 Service Manual page 101

– If an ATF temperature of 35 °C is achieved, unscrew the ATF
inspection plug -A-.
– Always replace gasket ring -arrows- for ATF inspection plug
⇒ Electronic Catalogue of Original Parts .
First of all the ATF in the overflow tube -arrow 2- drains off.
If more ATF drips out of the ATF inspection opening (approx. 1
drop per second) via the overflow tube before the ATF has
reached 40°C, the ATF level is correct.
– Fit ATF inspection plug -arrow 1- with a new gasket ring and
tighten to 27 Nm.
This completes the ATF level inspection.
Note
At the latest at 45 °C (in hot climate countries 50 °C) the ATF
inspection plug must be closed again.
If no ATF flows out at the ATF inspection opening up to 45 °C, the
ATF must be topped up
– End function "08 - read measured value block".
– Tip "06 - End output".
– Switch off ignition and unplug diagnostic connector.
– Install the noise insulation ⇒ Body Work; Rep. gr. 50 .
Shorten the vent pipe of the adapter for oil filling - VAS 6262A-
⇒ page 98 .
Octavia III 2013 ➤ , Octavia III 2014 ➤
Maintenance - Edition 12.2014
97
4. Gearbox