Skoda Octavia III 2013 Service Manual page 137

WARNING
Vehicles from MY 2013 are equipped with a two-channel serv‐
ice interval display with uniform service message.
Before reaching the service interval the "open-ended spanner"
symbol is displayed in the display when the ignition is switched
on and the following message is displayed:
♦ "Service in ... km or ... Days." or "SERVICE IN ... km OR ...
DAYS"
As soon as the service interval has been reached the "open-
ended spanner" symbol is displayed in the display when the
ignition is switched on and the following message is displayed:
♦ "Service now!" or "SERVICE NOW"
When resetting the service interval display using the buttons
in the dash panel insert the oil change service interval must
always be reset!
This also applies if an inspection must be performed on the
vehicle!
♦ Vehicles with service intervals -QI6- are automatically re‐
coded to -QI4- as a result of this procedure.
♦ A recoding to -QI6- is only possible with the diagnosis de‐
vice taking the conditions into account
⇒ "6.12 Changing the code of the service intervals", page
138 .
The inspection interval cannot be reset using the buttons!
It must therefore be checked or reset using the corresponding
dual channel service interval display (in 2 steps, i.e. for oil
change or for inspection) using the diagnostic unit -VAS-
⇒ page 132 .
– Switch off ignition.
– Hold the button -3- pressed and simultaneously switch on the
ignition.
– Release button -3- and press it again.
6.10.3 Reset service interval display from MY
2014
The service interval display is reset with the vehicle diagnosis,
measurement and information system -VAS-
The service interval display can also be reset with the buttons in
the dash panel insert ⇒ page 134
⇒ page 134 .
.
Octavia III 2013 ➤ , Octavia III 2014 ➤
Maintenance - Edition 12.2014
133
6. Electrical System