Skoda Octavia III 2013 Service Manual page 102

Octavia III 2013 ➤ , Octavia III 2014 ➤
Maintenance - Edition 12.2014
– Shorten the vent pipe to the dimension -a-, so that it does not
touch the bottom of certain ATF bottles.
Dimension -a-: 210 mm
Note
The dimension -a- is measured on the shaft (starting with the
green area in the detail) of the adapter for oil filling - VAS 6262A- .
Caution
♦ The filling hose and the adapter - VAS 6262- or -
VAS 6262A- must be clean and the ATF must not be
mixed with other oils!
Topping up ATF
Note
Pay attention to all the notes and test conditions
– Screw in the adapter for ATF oil filling - VAS 6262/2- by hand
in the location of the gearbox inspection plug -arrow 1- and
connect adapter for oil filling - VAS 6262- or -VAS 6262A- .
– Shake the ATF reservoir before opening.
Note
Before screwing in the adapter for oil filling at the ATF reser‐
♦
voir, check the length of the vent pipe and shorten if necessary
⇒ page 97 .
The adapter for the oil filling - VAS 6262- must be clean and
♦
the ATF for automatic gearbox 09G must not be mixed with
other ATF oils!
– Screw on ATF oil filling to the adapter for the oil filling - VAS
6262- and fill 1 litre ATF.
– Remove adapter for oil filling - VAS 6262- from adapter for ATF
oil filling - VAS 6262/2- .
– Observe whether ATF flows out of the opening of the adapter
for ATF oil filling - VAS 6262/2- .
If ATF flows out of the opening of the adapter for ATF oil filling -
VAS 6262/2- , the ATF level is correct.
– Allow all excess ATF to drip out until it starts to drain off.
If no ATF flows out of the opening of the adapter for ATF oil filling
- VAS 6262/2- but only drips, the ATF level is not O.K. and ATF
must be filled up.
– Unscrew adapter for ATF oil filling - VAS 6262/2- .
98
4. Gearbox
⇒ page 95 .