Check For Proper Operation Of Automatic Light; Check The Operation Of The Dynamic Cornering Light - Skoda Octavia III 2013 Service Manual

Hide thumbs Also See for Octavia III 2013:
Table of Contents

Advertisement

Note
To easily determine the kink -4- alternately cover and uncover
the left half of the headlight (in the driving direction) a few
times. After this, check the low beam once again.
The headlight setting on the control screen with adjusting line
15° -1- is analogous to the headlight setting on the control
screen without this adjusting line.
To prevent an incorrect headlight adjustment, the adjusting
line 15° -1- must not be observed however.
Fog lights
⇒ "6.18 Adjusting the fog light", page 143
Other additional headlights:
Additionally fitted headlights must be inspected or set in compli‐
ance with the relevant applicable directives.
6.14
Check for proper operation of automatic
light
This test must be performed in daylight.
– Turn the turning handle of the light switch to position
-automatic light-.
The headlights must not light up during daylight.
– Cover sensor for rain and light detection in the foot of the in‐
terior mirror from outside by hand or with a suitable object. This
reduces the luminous intensity of the daylight.
The headlights should light up.
– Uncover sensor for rain and light detection in the foot of the
interior mirror.
The headlights must go off.
Note
The headlights go off approx. 4 -5 seconds after uncovering the
sensor for rain and light detection.
6.15
Check the operation of the dynamic cor‐
nering light
This test is carried out on the vehicle while it is standing on its
wheels using the diagnostic unit -VAS- together with the corre‐
sponding diagnostic cable ⇒ Vehicle diagnostic tester.
– Switch on ignition and connect diagnostic unit
⇒ "6.9 Connect diagnostic unit and query event memory",
page 130
.
– Switch on low beam light.
– On the diagnostic device, select: "Targeted functions" → "Ško‐
da" → "Octavia 2013►" → "Engine type" and further → "Body
Work" and further → "Electrical system".
– Choose the "Presentation mode" function.
– Initiate test and proceed by referring to the read-out on the
display of the diagnostic unit.
Octavia III 2013 ➤ , Octavia III 2014 ➤
Maintenance - Edition 12.2014
141
6. Electrical System

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Octavia iii 2014

Table of Contents