Samsung OfficeServ 7100 Technical Manual page 28

OfficeServ 7100
TECHNICAL MANUAL
MMC: 806
DESCRIPTION:
Allows the preprogramming of a card slot for a specific board type. A board inserted
into a OfficeServ 7100 system will not be recognized by the system until it is
ENABLED using this MMC. Cards installed using MMC 806 will NOT be assigned in
the system numbering plan. You must then use MMC 724 to assign the desired
directory numbers to extensions or trunks ports.
NOTE: If a card is removed and a different type card is inserted and this MMC is
performed, the memory associated with that card (i.e. key programming, etc.) will
be erased.
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPEAKER
ACTION
1. Press TRANSFER 806.
Display shows.
2. Press the right soft key to move cursor to the
"S" or slot position. Press the UP or
DOWN key to advance the slot position, or
use dial pad to make selection (eg. Change
from DDN to DST) N=none, D=DLM,
S=SLM, T=TRM)
3. Use the RIGHT softkey to make selection.
4. Use the dial pad (1=YES, 0=NO) to make
selection.
5. Press the UP or DOWN key to advance the
SLOT position. Now the display will show
the daughter slot of the MP10 card.
D=DLM, W=SWM, N=NONE
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
CARD PRE-INSTALL
DISPLAY
C:1 – S:1
UNI-DDN->UNI-DST
C:1 – S:1
UNI-DDN->UNI-DST
C:1 – S:1
ARE YOU SURE?
C:1 – :SMP
MP10-D->MP10-D
PROGRAMMING
PART 2 APRIL 2007