Table of Contents
Advertisement
A.5
VGA Display Connector (UNO-4673A series)
Table A.7: VGA Adaptor Cable Pin Assignments
Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
A.6
SATA Hard Drive RAID Support (UNO-4683
Series)
In order to install an operating system onto a RAID volume, the RAID option must be
enabled in the system BIOS, a RAID volume must be created, and the F6 installation
method must be used to load the Intel Rapid Storage Technology driver during oper-
ating system setup.
Before you start, please make sure that two SATA hard drives have been mounted in
system. A USB floppy will be also required for some additional files.
A.6.1
Enable RAID in System BIOS
Use the instructions included with your motherboard to enable RAID in the system
BIOS.
1.
Click Del to enter the BIOS Setup program after the Power-On-Self-Test (POST)
memory test begins.
2.
Click the Integrated Peripherals menu.
3.
Click the OnChip IED Device menu.
4.
Switch the SATA Mode option to RAID to enable Intel® RAID Technology.
5.
Click F10 to save the BIOS settings and exit the BIOS Setup program.
5
10
15
Signal Name
Red
Green
Blue
NC
GND
GND
GND
GND
NC
GND
NC
NC
H-SYNC
V-SYNC
NC
31
1
6
11
UNO-4673A/4683 Series User Manual
Advertisement
Table of Contents
