3.
When you see a prompt that says, Please insert the disk labeled Manufacturer-
supplied hardware support disk into Drive A:, insert ;a floppy disk containing the
following files: IAAHCI.INF, IAAHCI.CAT, IASTOR.INF, IASTOR.CAT, IAS-
TOR.SYS, and TXTSETUP.OEM.
Note!
Use the Floppy Configuration Utility to create a floppy disk with the nec-
essary files or copy required file from driver folder.
4.
Press Enter.
5.
Select your controller from the list of available SCSI adapters. Use the up and
down arrow keys to scroll through the list as all controllers may not be visible.
6.
Press Enter to confirm your controller and continue. At this point, you have suc-
cessfully installed the driver and Windows setup should continue. Leave the
floppy disk in the floppy drive until the system reboots. Windows setup will need
to copy the files again from the floppy to the Windows installation folders. Once
Windows setup has copied these files again, remove the floppy disk so that
Windows setup can reboot as needed.
35
UNO-4673A/4683 Series User Manual