Table of Contents
Advertisement
3.1
Configuration
To open the chassis, please follow the steps below:
1.
Remove all power and signal connections
2.
Place the unit with the heat-sink side down
3.
Remove the plug-in module in the slot 3
4.
Remove the screws on the cover
5.
Install a Well-configured CompactFlash Card in this area
6.
Install a USB device in this area
7.
Refer to this manual to configure the COM ports
UNO-4673A/4683 Series User Manual
Figure 3.1 Location for Configuration
22
Advertisement
Table of Contents
