Table of Contents
Advertisement
2. Initial Assembly
STOP! FOR EASIEST ACCESS,
INSTALL FUEL CONVERSION
AND FIREBOX PANELS BEFORE
REMOVING THE STOVE FROM THE
PALLET.
Unpacking the Stove
EXCEPT AS NOTED, ALL INSTRUCTIONS ARE
ORIENTED FACING THE FRONT OF THE STOVE.
1. Open the Firebox
• The front door swings open to the left. Grasp it from
the right side or lower edge.
• Lift the Top Plate Grills and Top Plate from the stove and
set aside. Note: Reinstall Top Plate before installing venting.
• Remove the Latch Tool from the shipping pallet and
use it to remove the Glass Panel by pulling the two
latch hooks out to disengage them from the glass frame. Fig.
2.2.
• Tilt the glass frame forward, then lift it straight up
and off of the stove.
2. Remove the Miscellaneous Hardware kit from the firebox
and inspect the contents. Refer to the list on the previous
page and contact your dealer if any items are missing.
3. Optional Equipment and Burner Media: See Sections 11 and
12 for specific installation instructions.
CAUTION: Enamel parts may be damaged if
!
handled without care. The stove is heavy.
NOT DRAG THE STOVE LEGS.
Have assistance available to move the stove into position.
Place removed parts on a blanket, towel, or other
protective material.
Figure 2.2
Disengage the glass frame latches to open the firebox.
RE-INSTALL THE TOP PLATE BEFORE
CONNECTING VENT PIPE TO THE STOVE.
130112_Rev 2 GF 160 DV 2/22
DO
5
Advertisement
Table of Contents
