Final Assembly - Jøtul FS 74 Installation Instructions Manual

Fig. 17
B
A
3. NB: The product is heavy! Ask someone to help you place it
inside the surround.
4. Put the burn chamber's levelling screws (A) down on the
plate. We recommend using the two foam rubber grips (B)
to protect your hands. Push the burn chamber backwards
until it is in place. Remove the grips (B), adjust your hold and
carefully lower the front edge of the burn chamber. When the
burn chamber is in its place, screw the levelling screws back
again. Refit the insulation sheet.
Fig. 18
5. Refit the inner bottom, air duct and log retainer.

Final assembly

Fig. 19
B
1. Put the upper fireproof board into position and secure it
to the steel sides using the screws provided. NB: Screws
must not be used if the surround is to be installed against a
combustible wall.
2. Then finish fitting the top outlet with the flue pipe or steel
chimney (see the installation instructions for the steel
chimney).
Fig. 20
3. Position the top section. Make sure it is flush with the side
pieces and fireproof board.
4. Secure firmly on each side using the 4 bolts provided.
ENGLISH
A
B
C
43