Initial Assembly - Jøtul GF 305 DV IPI Installation And Operation Instructions Manual

2. Initial Assembly

STOP!
FOR EASIEST ACCESS, INSTALL
ACCESSORIES, (Premium Kit, Accent Lamp, Flame
Control, and/or Blower), BEFORE REMOVING THE
STOVE FROM THE PALLET. SEE PAGE 20 for details.
THE ACCENT LAMP MUST BE INSTALLED BEFORE
CONNECTING THE STOVE TO VENTING.
Unpacking the Stove
EXCEPT AS NOTED, ALL INSTRUCTIONS ARE ORIENTED
FACING THE FRONT OF THE STOVE.
1. Remove the steel Latch Tool from the pallet.
2. Open the Firebox
• The front door swings open to the left.
• Engage the Latch Tool with the holes in the sprung glass
frame latches, located on top of the firebox. See fig. 2.1.
The top plate can be lifted off for easier access. Pull
the latch hooks out to disengage them from the glass
frame.
• Tilt the glass frame forward,
then lift it straight up and out
the stove.
3. Remove the shipping strap and
packing material from the burner
using a 1/4" nut driver.
4. Backup Batteries: The battery
box is located in the stove
controls compartment, behind
the burner switch plate. See Fig.
15.1, page 31.
• Disengage the box from the
Velcro® base.
• Press and slide the cover panel
to open and orient the batteries
as diagrammed in the box.
Figure 2.1.
Use the Latch Tool to disengage both glass frame latches.
! CAUTION: Enamelled parts may be damaged
if handled without care. The stove is heavy.
Have assistance available to move it into position.
Place removed parts on a blanket, towel, or other
protective material.
RE-INSTALL THE TOP PLATE BEFORE
CONNECTING THE
VENT TO THE STOVE.
139843_A GF 305 DV IPI 8/17
Latch Tool
5