Product Disposal - Nakanishi COMBOX-NET.EIP Operation Manual

Network interface
Table of Contents

Advertisement

Problem
NS LED flashing
11
(red)
NS LED flashing
12
(green)
13
Motor does not run
Value displayed on
controller does not
14
match the motor
speed control value.
*Also check the Operation Manual of the controller and motor spindle in use in addition to the above.

14 PRODUCT DISPOSAL

When disposal of products is necessary, follow the instructions from your local government agency for proper disposal of
industrial components.
Description/
Probable Cause
Check the connection of the
LAN cable and the cable for
wire breaks.
Communication
Check around the
time-out
communication line for
devices or high-voltage lines
that may be sources of noise.
Connection
Check that the scanner is
standing by
operating normally.
Check if the scanner settings
Defective
are matched to the settings in
communication
"6-1 Communication
settings
Specifications."
Defective
Check the connection of the
communication
LAN cable and the cable for
connection
wire breaks.
Check if one of the data/ready
Data/ready occurred
bits is not ON.
Check if currently set bits are
Defective bit setting
correct.
Check if currently set bits are
Defective bit setting
correct.
Check if the motor speed
Motor spindle type
range of the currently used
does not match
motor spindle matches the
setting.
How To Check Cause
77
Remedy
Re-connect the LAN Cable.
Replace the cable if there is a wire
break.
Remove the noise source or adopt
measures such as removing the noise
source further away.
Referring to the Operation Manual of
the scanner, set to the correct
settings.
Review the communication settings.
Re-load the EDS file.
Re-connect the LAN Cable.
Replace the cable if there is a wire
break.
Referring to "11-4 Data/Ready
Details," remove the cause of the
error.
Correctly set the addresses and the
bit arrangement of the I/O data
currently set on the scanner.
Match the TYPE and PARAM settings
to the controller parameter settings.
Referring to "11 COMBOX-NET.EIP
I/O DATA <Motor Speed Setting>", set
to the correct combination.

Advertisement

Table of Contents
loading

Related Products for Nakanishi COMBOX-NET.EIP

This manual is also suitable for:

Ne339

Table of Contents