Table of Contents
Advertisement
8–2 Installation of COMBOX-NET.EIP Rear Input/output Cable
No.
Power Connector (socket side)
⑤
LAN port
⑥
RJ45
Activity
⑦
LED (green)
Link
⑧
LED (yellow)
D-Sub 25 connector
⑨
25 poles (socket side)
D-Sub 15 connector
⑩
15 poles (socket side) (high-density type)
8–3 Installation of Additional Sensor to COMBOX-NET.EIP, Setting Change Switches
No.
Digital sensor input connector (socket side)
⑪
DC+24V, Input: ON/OFF, 2 channels
NPN and PNP types supported
Analog sensor input connector(socket side)
⑫
DC+15V, Input: 0 to 5 V, 2 channels
DIP switches for setting the IP address
⑬
SW1-SW3
Motor speed adjustment knob
⑭
For adjusting the set motor rotation speed
⑩
Part Name
⑫
Part Name
⑦
⑨
⑥
Supplies 24 VDC power.
Connected to EtherNet/IP network.
Displays the data send/receive status.
Out: No data send/receive, Flashing: Data send/receive in progress
Displays the link status with other devices.
Out: No link, Lit: Link established
Connects to controller (E3000, E4000, E2280, iSpeed3, iSpeed5).
Connects to controller (E3000, E4000, E2280, iSpeed3, iSpeed5).
⑪
⑭ ⑬
Devices such as proximity sensors and fiber sensors that support
open collector output can be installed.
Devices such as thermometers, flowmeters and pressure gauges
that output analog voltage (0 to 5 V) can be installed.
The IP address of the COMBOX-NET.EIP main body can be set.
This knob is for adjusting the motor speed when there is a
difference between the motor speed set by the scanner and the
set motor speed display on the controller.
54
⑧
⑤
Contents
Contents
Advertisement
Table of Contents
