Nakanishi COMBOX-NET.EIP Operation Manual page 29

<Motor Current>
Address
Item Code
Data
・Other than iSpeed3
0 to 2000 (x10 mA/digit)
2byte
・iSpeed3
0 to 1000 (x10 mA/digit)
<Torque Load Monitor>
Address
Item Code
Data
・All models
2byte
0 to 200 (%/digit)
<Motor Speed (Voltage)>
Address
Item Code
Data
・All models
2byte
0 to 10000 (x10 min
<Sensor Voltage Output 1>
Address
Item Code
Data
2byte 0 to 5000 (mV/digit)
<Sensor Voltage Output 2>
Address
Item Code
Data
2byte 0 to 5000 (mV/digit)
<Motor Speed (Pulse)>
Address
Item Code
Data
・All models
2byte
0 to 10000 (x10 min
Output Value
Output Value
Output Value
-1 /digit)
Output Value
Output Value
Output Value
/digit)
-1
n+0x04
MOTOR_DT
The analog monitor that is output after conversion of the motor
current output from the controller to a voltage value is output as
binary data.
n+0x05
LOAD_DT
The analog monitor that is output after conversion of the motor
torque load output from the controller to a voltage value is output as
binary data.
n+0x06
SPD_DT
The analog monitor that is output after conversion of the motor
speed during motor rotation from the controller to a voltage value is
output as binary data.
n+0x07
SNS-1
Voltage 0 to 5 V input to SNS-1 of the analog sensor input
connector is output as binary data.
n+0x08
SNS-2
Voltage 0 to 5 V input to SNS-2 of the analog sensor input
connector is output as binary data.
n+0x09
SPD_PULSE
Arithmetic operation is performed on the rotating pulse output from
the controller to become the motor speed which is output as binary
data.
70
Description
Description
Description
Description
Description
Description