8–13 Motor Speed Adjustment Knob
This knob is for adjusting the motor speed when there is a difference between the motor speed set by the scanner and the
set motor speed display on the controller.
Turning the knob CW increases the set motor speed, and turning the knob CCW decreases the set motor speed.
CCW: Decreases
CW: Increases
Setting example (when motor speed is lower than setting value)
When the speed display on the controller indicated "59" when the set motor speed was set to 60 (60000 min-1) on the
scanner to instruct the motor speed, turn the adjustment knob CW to change the speed display setting to "60".
How to operate the motor speed adjustment knob
Turn the motor speed adjustment knob using an insulated flathead screwdriver. At this time, take sufficient care to
prevent static electricity from being generated. Failure to do so may cause a malfunction.
➊ Insert the insulated flathead screwdriver into the motor speed adjustment knob, and turn the screwdriver in the desired
direction to adjust the instructed motor speed on the controller.
①
➋ After adjusting the motor speed, install the rubber cover by referring to "8-4 Attaching Covers."
②
CW : Increases
②
CCW : Decreases
!CAUTION
62