8–1 COMBOX-NET.EIP Front Panel LED Display
①
<Monitor LEDs for STATUS status signal>
No.
Signal Code
PW1
Main power source
PW2
Sensor power source
CN
Controller connection
①
MS
Device status
NS
Network status
The MS and NS LEDs light in order MS (green)/NS (green) and MS (red)/NS (red) when the power is turned ON
(during the self test).
<Details of MS, NS lighting>
Signal Code
Lit, green
Flashing, green
MS
Lit, red
(Module Status)
Flashing, red
Out
Lit, green
Flashing, green
NS
Lit, red
(Network Status)
Flashing, red
Out
<Connector A: Monitor LEDs for D-Sub 25 input/output signals>
No.
INPUT
Signal Name
1
RUN
2
DIR_OUT
3
COIN
4
PULSE
②
5
SEL_MT
6
SEL_MT
ERR
ERR
WRN
WRN
Signal Name
24 VDC for main power is applied
24 VDC for sensor power is applied
D-Sub 25 connector is connected, controller power source is ON
According to device operating status
According to network communication status
Lighting Status
Normal operation
Device not set or setting incomplete
Non-recoverable abnormality
Recoverable abnormality
Power not supplied
Online, normal communication in progress
Online, no communication connection
IP address duplicated, fatal link error
Communication connection time error
Power not supplied/IP address not set
Function
Rotating
Rotating Direction
Speed Achievement
Rotating Pulse
Motor No.2 selected
Motor No.2 selected
Error
WARNING
②
LED Lighting Condition
NOTICE
Rotating
Reverse rotation is selected
Setting motor rotation speed is reached
Rotating pulse is input (flashing during rotation)
Motor No.2 is selected (E2280 in use)
Motor No.2 is selected (iSpeed3 in use)
Error occurred (flashing when error code is issued)
Warning occurred (flashing when warning code is issued)
52
③
④
Status
LED Lighting Condition