Nakanishi COMBOX-NET.EIP Operation Manual page 12

No. OUTPUT Signal Name
1 START
2 DIR_IN
3 RESET
4 500min
SEL0
5
UD_IN/
SEL0
SEL1
6
② CNT_IN/
SEL1
7 CNT_IN
UD_IN
8
MT_SEL
MT_SEL
9
ID0
10 ID1
<Connector B: Monitor LEDs for D-Sub 15 input/output signals>
No. INPUT Signal Name
1 MT-CN
2 SAFE1
3 SAFE2
③
4 AUTO
5 PWON
No. OUTPUT Signal Name
③ EMG EMG
<Monitor LEDs for SENSOR signal>
No. SENSOR Signal Name
1 S-OUT1
④
2 S-OUT2
 ②, ③ and ④ input/output signals are sent and received to and from the scanner in EtherNet/IP communications.
(Other than PULSE)
For details, see signals of the same name in "11 COMBOX-NET.EIP I/O DATA."
Function
Rotate Command
Rotating Direction
Error Release
-1 (rpm) 500min -1 (rpm)
Speed Point Select 0
UP/DOWN Signal for
Setting Motor Speed
Speed Point Select 0
Speed Point Select 1
Count Pulse Signal
for Setting Motor
Speed/Speed Point
Select 1
Count Pulse Signal
for Setting Motor
Speed
UP/DOWN Signal for
Setting Motor Speed
Motor Select
Motor Select
Motor Class Signal 0
Motor Class Signal 1
Function
Motor Connect Contact
Safety Relay 1
Safety Relay 2
Control Mode AUTO Signal
CONTROLLER Power Source
Monitor
Function
Emergency Stop
Function
Digital sensor 1
Digital sensor 2
Rotation is instructed
Reverse rotation is instructed
Error release is instructed
Motor speed 500 min
Speed point 0 is selected
・ Speed setting UP is instructed (E2280 in use)
・ Speed point 0 is selected (E2280 in use)
Speed point 1 is selected
・ Count pulse signal setting motor speed is input (E2280
in use)
・ Speed point 1 is selected (E2280 in use)
Count pulse signal for setting motor speed is input
Speed setting UP is instructed
Motor 2 is selected (E2280 in use)
Motor 2 is selected (iSpeed3 in use)
Motor class No.0 is selected (iSpeed5 in use)
Motor class No.1 is selected (iSpeed5 in use)
Motor is disconnected
・ Auxiliary contact is ON
・ Motor 2 is selected (E2280, iSpeed3 in use)
・ Auxiliary contact is ON
・ Motor 1 is selected (E2280, iSpeed3 in use)
In AUTO mode
Controller power source is detected
Emergency stop is in progress
Digital sensor 1 is ON
Digital sensor 2 is ON
NOTICE
53
LED Lighting Condition
-1 is selected
LED Lighting Condition
LED Lighting Condition
LED Lighting Condition