Gas Distribution Block - Siemens KION Service Manual

KION / KION-i
E382 E392E 061 01 02 02

Gas distribution block

• Disconnect the three gas tubes (1) from the gas
modules.
Note: This disconnection will depressurize the gas
distribution block which must be done before
disassembling the block.
6
• Remove the two screws (2) and lift off the gas
connection housing (3) from the gas distribution
block.
9
There may still be some gas pressure left in the
gas channels inside the gas distribution block
causing the valve housings (OV1–OV3) to "pop-
H
out".
• The gas inlet filters (4) with gaskets (5) in the gas
connection housing are now accessible.
Note: These gas inlet filters was not included at
start of KION production and are thus not fitted in
;
units with S/N below approx. 325.
<
Siemens-Elema AB
Disassembling and assembling
4 - 9
4