Table of Contents
Advertisement
x
012
... 00 0C ...
100
x
013
... 00 0D ...
100
x
015
... 00 0F ...
100
x
016
... 00 10 ...
x
020
... 00 14 ...
x
021
... 00 15 ...
x
023
... 00 17 ...
ALA: DIAG_EMERGENCY_TEST_CONTROL
ALA: DIAG_EMERGENCY_TEST_PANEL
ALA:
DIAG_EMERGENCY_LINE_ACTIVE_ERROR
ALA: DIAG_CAN_SEND_TIMEOUT
ALA: DIAG_TECH_ERR_BUFF_OVERFLOW
ALA: DIAG_LOW_BATTERY_CAPACITY_
DURING_BATTERY_TEST
ALA: DIAG_INTERNAL_ERROR
Fault: Hardware failure.
Description: ALA orders CON to pull emergency line. The startup hardware
emergency line test failed. Technical alarm is generated.
What to do: Replace PC 1730 Control.
Fault: Hardware failure.
Description: ALA orders PAN to pull emergency line. The startup hardware
emergency line test failed. Technical alarm is generated.
What to do:
1.
Check that the PAN-PROM is correctly mounted
2.
Replace PC 1672 Control Panel.
Fault: Hardware failure.
Description: The startup hardware test failed because the emergency line was
already active before the emergency line-, sound- or the voltage test. Technical alarm
is generated.
What to do:
1.
Check if the faulty PC board can be identified by another adjacent diagnostic
log
2.
Replace PC 1737 Measuring
3.
Replace PC 1730 Control
4.
Replace PC 1672 Control Panel.
Fault: Communication bus (CAN) is not working.
Description: The CAN driver reports an Timeout error.
What to do:
1.
Replace PC 1672 Control Panel.
2.
If this log is repeted several times; check CAN communicating units, i.e.
microprocessor controlled PC boards, multigas analyzer, KION Monitor and
DuoView. Also check PC board- and cable connectors.
3.
Report to EM-HSC.
Fault: Technical Error Buffer Overflow.
Description: There is no room for this alarm in buffer.
What to do: Report to EM-HSC.
Fault: Battery capacity is low.
Description: Low battery capacity during internal battery test.
What to do: Replace internal battery.
Fault: Internal program error.
Description: For debugging purpose.
What to do: Report to EM-HSC.
Advertisement
Chapters
Table of Contents
