Advertisement
Chapter 2) 7SR17Rho Settings & Instruments
Section 2: Setting & Configuring the Relay Using Reydisp
Evolution
To set the relay using a communication port the user will need the following:-
PC with Reydisp Evolution Version 7.1.5.6 or later Installed. (This can be downloaded from our website
www.siemens.com/energy
service pack 4 or above, or windows XP with service pack 2 or above and Microsoft.NET framework for tools.
2.1
P
C
HYSICAL
The relay can be connected to Reydisp via any of the communication ports on the relay. Suitable communication
Interface cable and converters are required depending which port is being used.
2.1.1
Front USB connection
To connect your pc locally via the front USB port.
2.1.2
Rear RS485 connection
Chapter 2) Page 18 of 22
and found under the submenu 'Software') This software requires windows 2000-
ONNECTION
Figure 2.1-1 USB connection to PC
Figure 2.1-2 RS485 connection to PC
©2014 Siemens Protection Devices Limited
Advertisement
Chapters
