Section 2: Setting & Configuring The Relay Using Reydisp Evolution; Physical Connection; Front Usb Connection; Rear Rs485 Connection - Siemens 7SR10 Argus Series Manual

Section 2: Setting & Configuring the Relay Using Reydisp
Evolution
To set the relay using a communication port the user will need the following:-
PC with Reydisp Evolution Version 7.1.5.6 or later Installed. (This can be downloaded from our website and
found under the submenu 'Software') This software requires windows 2000-service pack 4 or above, or windows
XP with service pack 2 or above and Microsoft.NET framework for tools.
2.1

Physical Connection

The relay can be connected to Reydisp via any of the communication ports on the relay. Suitable communication
Interface cable and converters are required depending which port is being used.
2.1.1

Front USB connection

To connect your pc locally via the front USB port.
Local
Engineer
Access
2.1.2

Rear RS485 connection

Laptop computer
© 2018 Siemens Protection Devices Limited
USB Type A
Socket on PC
USB Type A
USB connection to PC
Figure 2-1
USB or 9 pin male
D connector
RS232 straight
through cable or
USB to RS232
25 pin male D
Converter cable
connector
RS485 connection to PC
Figure 2-2
7SR10 Settings & Instruments Guide
USB Type B
USB Data Cable
RS232 to RS485
Converter
RS485 Screened
twisted pair
Chapter 2 Page 15 of 18
USB Type B
socket on Relay
A
B
Rear terminals