Siemens 7SR17 Rho Manual page 224

Chapter 4) 7SR17 Rho - Data Communications
Appendix 1
The operating mode of the device is set via the setting, or through a command sent to a communications port. There
are four options; Local, Remote, Local or Remote and Service.
The following table illustrates whether a function is Enabled ( ) or Disabled ( ) in each mode.
Function
Control
Com1
Com2 (USB)
Com3
Com4
Fascia (Control Mode)
Function Key (n)
Binary Input (n)
Binary Outputs
Reporting
Spontaneous
IEC
DNP3
General Interrogation
IEC
DNP3
MODBUS
Change Settings
Com1
Com2 (USB)
Com3
Com4
Fascia
Historical Information
Waveform Records
Event Records
Fault Information
Setting Information
Chapter 4 - Page 74 of 75
Local
when Com1-Mode = Local
when Com2-Mode = Local
when Com3-Mode = Local
when Com4-Mode = Local
when BI (n) Mode = Local
when Com1-Mode = Local
when Com2-Mode = Local
when Com3-Mode = Local
when Com4-Mode = Local
Fig. A1 Operating Mode Table
Operation Mode
Remote
when Com1-Mode = Remote
when Com2-Mode = Remote
when Com3-Mode = Remote
when Com4-Mode = Remote
when F Key(n) Mode = Remote
when BI (n) Mode = Remote
when Com1-Mode = Remote
when Com2-Mode = Remote
when Com3-Mode = Remote
when Com4-Mode = Remote
© 2013 Siemens Protection Devices Limited
Service