Using Reydisp Evolution
5.2 Connecting to the Relay for Setting via Reydisp Evolution
5.2
Connecting to the Relay for Setting via Reydisp Evolution
When Reydisp Evolution software is running, all available communication ports will automatically be detected.
On the start page toolbar, open the sub-menu File and select Connect.
The Connection Manager window will display all available communication ports. With the preferred port
highlighted, select the Properties option and ensure the baud rate and parity match that selected in the
relay settings. Select Connect to initiate the relay-PC connection.
[sc_pccomportselection, 1, --_--]
Figure 5-1
The relay settings can now be configured using the Reydisp Evolution software.
NOTE
i
i
•
In Reydisp Evolution, verify that Do NOT Check Communications Connection is selected in the
Advanced properties
•
In Reydisp Evolution, ensure that the Relay Address is set as 1 in the Relay menu for the 7SR450[1/3]-
xGx10-1AA0 variants
•
In Reydisp Evolution, ensure that the Relay Address in the Relay menu is the same as that of the Device
address for the 7SR450[1/3]-x[H/J]A20-1AA0 and 7SR450[2/4]-x[H/J]B20-1AA0 variants.
62
PC Com Port Selection
Reyrolle, Operating, Manual
C53000-B7040-C101-1, Edition 08.2020