Chapter 5) 7SR17 Installation Guide
Section 4: Rear Terminal Drawings
4.1
E4 C
ASE
Figure 4.1-1 E4 Case viewed from rear
Notes
1) Recommended terminations are pre-insulated and must be crimped using approved tooling.
2) RS485 (Block "B" Terms 14, 16, 18, 20) connection to this communication facility is by screened,
twisted pair cable. On site when wiring other facilities ensure that these terminals are not obscured by
other wiring runs. Cable should be RS485 compliant.
Page 10 of 18
©2014 Siemens Protection Devices Limited