Work Space Components - Thermo Scientific BB 150 User Manual

4. Description of the device
NOTE – Alarm contact
The alarm contact receives only messages
caused by work space atmosphere conditions
(temperature or gas).
Power supply connection:
Fig. 9: The power supply connection [5] of the device is esta-
blished via a cable with a connector for non-heating appliances.
The holder for the two device fuses is integral to the power supply
socket.
4.9

Work space components

The working surface of the incubator has been designed to
minimize the surface area. This helps to reduce condamina-
tion and promotes easy of cleaning.
Internal chamber:
All components of the work space are made of stainless steel
and have a burnished, absolutely smooth and easy-to-clean
surface. Any embossings have a large radius.
As an option, the interior container, the shelf system, and the
blower wheel with its cover can be made of copper material.
NOTE – Oxidation of copper components
When exposed to heat and humid air, the cop-
per material of the interior container will oxi-
dize. This results in a discoloration of the
copper components during the test run for
checking the device functions.
Do not remove the oxide layer during routine
cleaning as this has an antimicrobial effect.
Fig. 9: The components of the shelf system can be removed
easily so that only the easily treatable, surface-reduced internal
chamber [1] remains in the work space for cleaning and ma-
nual disinfection works.
Water reservoir:
Fig. 9: The water reservoir [2] is integral to the internal chamber
floor and inclines toward the rear. The embossing in the wa-
ter tray is used to indicate minimum level [3] and the maximum
level [4].
Fig. 9
Work space layout,
Water reservoir
CO Incubator BB 150 Operating Instructions
2
21