Disposal - Thermo Scientific BB 150 User Manual

13.

Disposal

CAUTION – Contamination hazard!
The device can be used for preparing and pro-
cessing infectious substances so that the
device or device components may become
contaminated.
Before device components are discarded, they
must be decontaminated!
• The device components must be cleaned
thoroughly; after the cleaning, they must be
disinfected or sterilized, as required by the
application.
• Discarded devices or device components
must be provided with an appropriate cer-
tificate showing the decontamination mea-
sures performed.
All device components can be discarded properly after they have been decon-
taminated properly.
NOTE – Recycling service
Thermo Fisher Scientific Products offer, for a
small fee, an environmentally compatible re-
cycling service for discarded devices.
Component
Thermal insulation components
Printed circuit boards
Plastic components, general
Exterior housing
Device rear panel
Outer door
Door inner panel
Operating panel and indicator foil
Magnetic door seal
Heating
Interior containers, installed components
and shelves
Plug for pipe channel
Pressure compensation opening insert
Glas screen
Glass door seal, measurement opening
Sensor block
Blower wheel
Measuring cell baseplate seal
Cables
Packaging
Material
Polystyrene foam EPS/PPS-Compound
Enclosed electrical components coated with different
plastics, equipped on epoxy resin-bound boards.
Note material labelling
Galvanized steel sheet, painted
Galvanized steel sheet
Galvanized steel sheet, painted
Galvanized steel sheet, painted
Polyethylene
Magnetic core sheathed with EMPP
Silicone-sheathed resistance-type wires
Stainless steel 1.4301 or copper
Silicone
POM with brass sinter filter
Soda-silicate glass
Tempered silicone
Stainless steel 1.4301
Stainless steel 1.4305 or copper
Tempered silicone
Plastic-sheathed copper flexible
Corrugated board, polyethylene film, and styrofoam
CO
2
Incubator BB 150 Operating Instructions
65