Interacoustics AD629 Instructions For Use Manual page 9

It is recommended that the disposable foam ear tips supplied with the optional EarTone5A insert transducers
are replaced after each patient tested. Disposable plugs also ensure that sanitary conditions exist for each of
your patients, and that periodic cleaning of a headband or cushion is no longer required.
The black tubing protruding the foam ear tip is attached to the sound tube nipple of the insert
•
transducer
• Roll the foam tip into the smallest possible diameter
Insert into the ear canal of the patient
•
• Hold the foam tip until expanded and a seal is achieved
After testing the patient, the foam tip including the black tubing is detached from the sound tube
•
nipple
The insert transducer should be examined prior to attaching a new foam tip
•
The AD629 is not intended to be used in oxygen rich environments or use in conjunction with flammable
agents.
CAUTION
NOTICE
To prevent system faults take appropriate precautions to avoid PC viruses and similar.
Using operating systems where Microsoft have discontinued software and security support will increase the
risk for viruses and malware, which may result in breakdowns, data loss and data theft and misuse.
Interacoustics A/S cannot be held liable for your data. Some Interacoustics A/S products support or may
work with operating systems unsupported by Microsoft. Interacoustics A/S recommends you to always use
Microsoft supported operating systems that are kept fully security updated.
Use only transducers calibrated with actual AD629. To identify a valid calibration, the serial number for the
AD629 will be marked on the transducer.
Within the European Union it is illegal to dispose electric and electronic waste as unsorted
municipal waste. Electric and electronic waste may contain hazardous substances and therefore
has to be collected separately. Such products will be marked with the crossed-out wheeled bin
shown below. The cooperation of the user is important in order to ensure a high level of reuse
and recycling of electric and electronic waste. Failing to recycle such waste products in an
appropriate way may endanger the environment and consequently the health of human beings.
To prevent system faults, take appropriate precautions to avoid PC viruses and similar.
D-0133833-A – 2022/09
AD629 - Instructions for Use - EN
Although the AD629 fulfills the relevant EMC requirements, precautions should
be taken to avoid unnecessary exposure to electromagnetic fields, e.g., from
mobile phones, etc. If the device is used adjacent to other equipment it must
be observed that no mutual disturbance appears. Please also refer to the
appendix regarding EMC.
Use of accessories, transducers, and cables other than specified, with the
exception of transducers and cables sold by Interacoustics or representatives,
may result in increased emission or decreased immunity of the equipment. For
a list of accessories, transducers and cables that fulfil the requirements please
also refer to the appendix regarding EMC.
Page 6