General; Authorized Use - probst STAZ-SLC Operating Instructions Manual

General

3 General
3.1

Authorized use

The device STAZ-SLC is specially applicable for the use on fork lift.
This device is exclusive applicable for gripping and transporting of large elements or vertically steel strapped and
non-steel strapped packs of stones, which are not exceed the load capacity of the device.
The gripping arms are full hydraulic parallel displaceable (through sliding guides).Therefore is an hydraulic circuit
necessary.
The gripping of conic gripping goods is not allowed.
This device is series-produced equipped with the
following elements:

The device is only designed for the use specified in this documentation.

Every other use is not authorized and is forbidden!

All relevant safety regulations, corresponding legal regulations, especially regulations of the declaration
of conformity, and additional local health and safety regulations have to be observed.
Prior to every operation the user must ensure that:

The equipment is suited to the intended operation, the functioning and the working condition of the
equipment is examined, and the load is suitable to be handled.
Any doubts about instructions should be raised with the manufacturer prior to use.
ATTENTION: The use of this device is only permitted in proximity to the ground ( chapter "Safety at
work")
Only stone elements with parallel and plane surface are allowed to be picked-up and handled.
Because the gripping good could fall down.
5705.0015

manually adjustable pressure valve

oil pressure gauge

wide opening range of the gripping arms

exchangeable rubber grippers
V7
9 / 22
GB