Installation; Mechanical Connection; Attachment With Crane Boom (Optional); Load Centre - probst STAZ-SLC Operating Instructions Manual

Installation

4 Installation
4.1

Mechanical connection

Use only original accessories, in case of doubt consult the manufacturer.
Take care that the carrying capacity / working load limit (WLL) of the lifting device/carrier is not exceeded,
through the load of the device, the attaching devices (turning device, fork sleeves etc.) and the additional
load of the gripping goods!
4.1.1

Attachment with crane boom (optional)

To connect the crane boom to the forklift truck,
position the lift blade below the upper brackets
and fix the lower brackets.
4.1.2

Load Centre


When dimensioning a forklift truck, it is assumed, that the mount point is completely retracted,
when in normal drive mode. Therefore, the distance of the load centre is small.

When using attachments, especially when using a distance adjustment VA, the distance of the load
centre is increasing, whereby the carrying capacity / working load limit of the fork lift tuck is
decreasing.

Only when the load is lifted ~10 cm (~ 4") above the storage area (e.g. lorry bed) and only when the
forklift stands still, it is allowed to move the mount point forward hydraulical, to put down the
gripping good.

After putting down the gripping good, the moint point (the distance adjustment VA) has to be
retracted immediately.
5705.0015
Upper brackets
Fork lift blade
Lower brackets
V7
12 / 22
GB