What To Do If Your Appliance Does Not Work - Moulinex ClickChef HF4SPR30 Manual

WHAT TO DO IF YOUR APPLIANCE DOES NOT WORK

Problems
Volume of ingredients is too large.
The seal is not there.
Leaking from the lid.
The seal is cut, damaged.
EN
Wrong accessories.
The sub-lid is not there.
The seal (B2) is not properly positioned.
Leakage through the bowl
The seal (B2) is damaged.
drive shaft.
The locking ring is poorly tightened.
When using the appliance for the first time, or in
Smell coming from the the event of motor overload caused by too large a
motor. quantity of ingredients or pieces that are too hard
or too big.
The blades do not turn
Food pieces are too big or too hard.
easily.
"E1" display Product failure
"E2" display Product failure
The bowl is not on the motor block or it is
"E3" display incorrectly positioned on the engine block. The lid
is not properly locked in place.
Appliance overheating. The appliance has been
"E4" display
used too intensively or with too many ingredients.
CAUSES SOLUTIONS
Reduce the quantity of ingredients used.
Position the sealing joint (A4) on the sub-lid (A3) and
clip this assembly onto the lid (A2).
Change the seal, contact an authorised service
centre.
Check that you are using the recommended
accessory.
Clip the sub-lid fitted with its seal to the lid.
Correctly position the seal.
Contact an authorised service centre.
Lock the ring correctly.
Allow the engine to cool down (approximately 30
minutes) and reduce the quantity of ingredients in
the bowl.
Reduce the size or the quantity of ingredients
used. Add liquid.
Contact the After Sales Centre, indicating the error
displayed.
Contact the After Sales Centre, indicating the error
displayed.
Remove the bowl from the engine block, properly
lock the lid in place and put the assembled set
back on the motor block. If the fault persists, bring
the appliance to the After Sales Service
Leave the appliance to rest for 30 mins, then turn it
off and back on again using the main switch (0/1).
Reduce the quantities of ingredients in the bowl.
If the error reappears quickly, increase the resting
time or reduce the ingredients. If the fault persists,
bring the appliance to the After Sales Service
78
Problems CAUSES
"E5" display Temperature sensor overheating.
"E6" display Product failure
Is your appliance still not working?
Please refer to an authorised service centre (see the list in the service leaflet).
RECYCLING
• Disposal of packaging materials and the appliance
The packaging is comprised exclusively of materials which do not pose danger to the environment, and
which can be disposed of in accordance with recycling provisions in force.
To scrap the appliance, inquire with the appropriate services in your area.
• Electronic products or electrical products at end of life:
Protect the environment!
Your appliance contains many valuable materials which can be recovered or recycled.
Give it to a collection point for processing.
SOLUTIONS
Leave the bowl to cool for 30 mins and then turn
it off back on again using the main switch (0/1).
Be sure to cook the ingredients with a minimum
amount of fat or water depending on the recipe
being used. If the problem persists, return the
appliance to the After Sales Centre, indicating the
error displayed.
Bring the appliance to the After Sales Centre,
indicating the error displayed.
79
EN