Wiring - Optex ELITE PRO Instruction Manual

Wiring

Wire the OC-907C T.
CAUTION CAUTION
Do not turn the power on while wiring. Otherwise, electric shock or device damage may result.
„ OC-907C T
Power harness × 1 and door controller interface × 2 (for double door left and right sides) are included.
• Power harness
36"
(920 mm)
Name
1. Power (*1)
2. Power (*1)
*1: No polarity.
• I/O harness
I/O harness × 2
(for double door left and right sides)
Name
1. Activation output
2. Activation output
3. None
4. None
5. Stall output
6. Stall output
7. Test input
8. Test input
9. BodyGuard input or
Motor voltage input
10. BodyGuard input or
Motor voltage input
11. None
12. None
13. Knowing act input
14. Knowing act input
15. Close switch input
16. Close switch input
10
Color Specifications
Orange 12 to 30 VDC
Brown
4'3''
(1300 mm)
Color I/O
Yellow Output
Yellow Output
- -
- -
Green Output
Green Output
Pink Input
Pink Input
Red Input
Red Input
- -
- -
Purple Input
Purple Input
White Input
White Input
Specifications
Form A relay 50 V, 0.3 A (resistance load)
At power OFF: Open
At stand-by: Open, at detection: Close
-
Form A or B relay 50 V, 0.3 A (resistance load)
Set form A or B with the setting app.
When setting N.O.
At power OFF: Close
At stand-by: Open
At detection: Close
When setting N.C.
At power OFF: Close
At stand-by: Close
At detection: Open
Optocoupler voltage 5 to 30 VDC, current 6 mA max. (30 VDC) (no polarity)
Optocoupler voltage 5 to 160 VDC, 5 to 120 VAC, 60 Hz (no polarity)
-
Dry contact input
Connect push plate, etc.
Dry contact input
Connect a device recognizing door fully closed status (a magnet switch, etc.).