Optex ELITE PRO Instruction Manual page 9

„ Step 4) Connecting the door front/back
OA-607 T
1
Connect the pass through harness to the left end of
the door front OA-607 T and pass it through the 3/8"
(10 mm) hole.
Connect the pass through harness to the right end of
the door back OA-607 T.
Pass-though harness 210 mm
Door back sensor
Connect to front
sensor right end.
* Insert the connector firmly to the base. If the insertion is
loose, a communication error with OA-607 T may result.
When a communication error is generated, the sensor
operation indicator will blink Orange twice.
„ Step 5) Setting the OA-607 T dipswitches
and adjustment of detection angle
Make the following settings for OA-607 T.
• Dipswitches
• Detection angle
See Function settings.
See Detection area adjustment.
NOTE NOTE
Make sure that the detection angle is +5°.
If the detection angle needs to be changed, see Detection
area adjustment.
„ Step 6) Fitting the cover on OA-607 T
1
Put the cover on from above and fit it in.
Pass the loop harness through the notch on the cover
side.
* Be careful not to disconnect the cable with the cover.
2
Install the remaining sensors similarly.
Door front sensor
„ Step 7) OC-907C T and door controller I/O
wiring and OC-907C T power wiring
1
Connect I/O wiring between the OC-907C T door con-
Connect to front
troller connector and the door controller.
sensor left end.
Pass the
pass-through
harness
through the
3/8" (10 mm)
hole.
With regard to the door controller connector, for single
swing doors the door controller can be connected to either
the right or left sensor connector. For double swing doors,
the door controller installed on left/right doors can be con-
nected to either the right or left connector (note that left/
right must be aligned for the sensor connector).
Wire in accordance with the door controller specifications.
2
Connect power wiring to the OC-907C T power con-
nector.
The power connector is connected to 12 to 30 VDC with a
power harness.
Notch
NOTE NOTE
WARNING WARNING
NOTE NOTE
Door controller
I/O harness
Connect to the
door controller
on the other
side.
Power harness
9