Table of Contents
Advertisement
„ Step 1) Installing OC-907C T and
connecting the loop harness
1
Using the hook-and-loop fastener included as stan-
dard, attach OC-907C T to the transom.
2
Connect the larger loop harness connector to the OC-
907C T sensor connector.
OC-907C T
sensor controller
sensor connector
NOTE
NOTE
With regard to the sensor connector, for single swing
doors the OA-607 T can be connected to either the right or
left sensor connector. For double swing doors, the OA-607
T installed on left/right doors can be connected to either
the right or left sensor connector (note that left/right must
be aligned for the door controller connector).
Loop harness 2200 mm
To OA-607 T
Smaller connector
3
Pass the loop harness through the transom and jamb.
To do so, drill a 3/8" hole in the transom.
* Later (see step 3-3), a hole will be drilled in the jamb for
the loop harness to emerge.
„ Step 2) Installing OA-607 T
1
Decide in advance which side of the door (swing side
or approach side) to install the door loop on.
2
Positioning the door template
Position the template edge at the door edge.
If through holes need to be drilled,
door front/back through hole
Since the holes here are penetrated
on both sides, the height of the both
templates should be roughly adjusted.
The door front/back through hole position should match on
both sides of the door.
Door front/back through hole Since the holes here are
penetrated on both sides, the height of the both templates
should be roughly adjusted.
6
For double doors, connect another
sensor connector as well.
To OC-907C T
Larger connector
Door template (R)
Position the door template
end at the door end
3
Paste the door template on.
The template top should be between 6'7" and 8'2" from
the ground.
When the template is accurately positioned, align the 3/8"
through hole so that it matches on both sides of the door.
4
Drill 1/8" (3.2 mm) left and right mounting holes for
OA-607 T on each side of the door leaf (in accordance
with the door template).
5
Drill a 3/8" cable door through hole.
Door template (R) "A"
The approach side template hole "A" must be perfectly
aligned with the swing side template hole "A".
6
(Only on the door loop mounting door side)
Drill 1/8" (3.2 mm) holes at the door loop cover right
and left (in accordance with the door template) (one
side of the door leaf only).
Door template (R)
Door
template (R)
Advertisement
Table of Contents
