Function Settings - Optex ELITE PRO Instruction Manual

Function settings

Set the OA-607 T and OC-907C T.
For setting, use the dipswitches for each device or the setting app. For more detailed settings, use the setting app.
„ OA-607 T
For setting OA-607 T, use the dipswitch or the setting app.
z Dipswitch settings
(thick-bordered box): Factory default settings
SW Function
1 Door width
2 Not used
3 Sensitivity
4 Immunity
5 Not used
6
7
8
NOTE NOTE
1: Dipswitch settings can be switched with conductivity status.
2: When the sensor controller dipswitch #1 (priority setting) is OFF (dipswitch priority), #1 to #8 above are enabled.
3: For detailed setting, set the sensor controller dipswitch #1 (priority setting) to ON (setting app priority) and the sensor controller dipswitch #2
(Wi-Fi setting) to ON (using Wi-Fi communication), and set from the setting app.
„ OC-907C T
For setting OC-907C T, use the dipswitch or the setting app.
Reset switch
2 s press: Reset password (after 2 s, the operation indicator will turn off and return to normal operation).
10 s press: Reset settings to factory defaults (after 10 s, the operation indicator will turn off and return to normal operation).
z Dipswitch settings
(thick-bordered box): Factory default settings
SW Function
1 Setting priority
2 Wi-Fi
3 Knowing act
4 Test output
(Activation)
5 Mandatory
6
7
8
NOTE NOTE
1: Dipswitch settings can be switched with conductivity status.
2: When the sensor controller dipswitch #1 (priority setting) is OFF (dipswitch priority), #2 to #8 above are enabled.
3: For detailed setting, set this dipswitch #1 (priority setting) to ON (setting app priority) and dipswitch #2 (Wi-Fi setting) to ON (using Wi-Fi
communication), and set from the setting app.
Setting
42"/48"
Low
ON
Setting
App
ON
Enable
Enable
36"
OFF
Normal
OFF
OFF
Dipsw
OFF
Disable
Disable
OFF
15