Details Of Error Status And Remedy (Aculaser C1000) - Epson ACULASER COLOR 2000 Service Manual

EPSON AcuLaser C2000 / AcuLaser C1000
Replace Oil Roll
Explanation
End of Fuser Oil Roll life. The remaining life is counted in the engine.
LED
The On Line LED and Continue LED are off.
Treatment Method
Open Cover A and replace Fuser Oil Roll with new one. Close Cover A
then the error will be cancelled automatically. Remaining of Fuser Oil
Roll returns 100%.
Replace Transfer Belt
Explanation
It is regarded that the Transfer Belt Unit service life is end, based on
the total number of revolution of the Transfer Belt up to now from
previous replacement. And printing is stopped.
LED
The On Line LED and Continue LED are off.
Treatment Method
Open the Front cover. Then remove the Photoconductor Unit and
replace the Transfer Belt Unit with new one. Then reset
Photoconductor Unit. Close the Front cover, then the error will be
canceled automatically.
Printer Open
Explanation
Front cover, Cover-A, Cover-B or Cover DM is/are open.
LED
The On Line LED and Continue LED are off.
Treatment Method
Close all cover and the error will be canceled automatically.
Troubleshooting
3.2.3.2 Details of Error Status and Remedy
(AcuLaser C1000)
Check Duplex P-Size
Description: Since the paper size fed in duplex printing was different
from the paper size in a paper cassette detected (or the
paper size in the MP tray specified by data), printing
stopped and a paper jam occurred.
The printer will recover from this error when the detection
of the paper jam is canceled.
After error recovery, the data for one page is recovered if it
is still retained in the printer memory, but if the data cannot
be recovered, the printer returns a status of resending
request. Recovery is achieved when a flying start is not
performed.
Remedy: Insert paper of the appropriate size, open covers over
paper feeding routes and remove jammed paper, then
close the covers. Printing resumes from the jammed page.
Pop-up display of the EPSON Status Monitor disappears
after error recovery.
Check Media Type
Description: Since paper other than transparencies was fed for
transparency printing, or a transparency was fed for non-
transparency printing, the printer canceled printing and
ejected the sheet.
If a transparency is fed by mistake for duplex printing, the
sheet remains in the duplex print unit, thus causing a
paper jam.
The Continue command of the ESCPAGES-02 protocol
releases the error in the printer engine, and the printer
recovers from the error. The ResetPrinter command
releases the error in the printer engine and resets the
printer to the initial status.
After error recovery by the Continue command, the data
for one page is recovered if it is still retained in the printer
memory, but if the data cannot be recovered, the printer
returns a status of resending request. Recovery is
achieved when a flying start is not performed.
Printer Message
Revision E
116