Limitations To Network Printing (Details Are Now Under Review) (Only For Aculaser C1000); Other Information (Only For Aculaser C1000) - Epson ACULASER COLOR 2000 Service Manual

EPSON AcuLaser C2000 / AcuLaser C1000
1.7.2 Network Environment (Only for AcuLaser
C1000)
Table 1-39. Network Environment (Only for AcuLaser C1000)
Windows Windows
95/98/Me NT4.0/2000
1
LPR *
1
Port 9100 *
FTP × * 4
IPP × * 4
NetBEUI × * 4
AppleTalk -
Netware × * 3
NDPS Gateway × * 4
: Recommended environment
×: Print quality is not guaranteed.
NOTE: User can send data to AcuLaser C1000 and printing will be
done. But print quality is not guaranteed in this case.
This is because Status Monitor can not communicate with
AcuLaser C1000.
<Explanation>
For printing with a host-based printer, the Status Monitor must
always communicate with the printer. If this communication is
impossible, user can not get any printer status and can not
clear any printer error because the printer has no LCD and no
switches.
*1: EpsonNet DirectPrint is necessary for use of LPR or Port 9100 on Windows95/
98/Me.
*2: For LPR or Port 9100 on Windows NT4.0/2000, Windows standard LPR or Ep-
sonNet Direct Print can be used.
*3: Default setting of NetBEUI and Netware is "ENABLE" in Leo 2.1. But AcuLaser
C1000 does not support these protocols because Status Monitor can not com-
municate with AcuLaser C1000 via these protocols.
The network setup section in AcuLaser C1000 manual describes that user or ad-
ministrator should set NetBEUI and Netware protocol to DISABLE.
*4: FTP, IPP and NDPS Gateway protocols can not be set to DISABLE and users
can send data to AcuLaser C1000 via these protocols. But the Status Monitor
can not communicate with the printer via these protocols, so these protocols are
Product Descriptions
Mac Remarks
2
* -
2
* -
× * 4 -
× * 4 -
× * 3 -
-
× * 3 -
× * 3 -
Engine Restrictions and Other Restrictions
out of guarantee.
AcuLaser C1000 manual describes that these protocols are out of guarantee.
1.7.3 Limitations to Network Printing
(Details are now under review)
(Only for AcuLaser C1000)
Only Leo 2.1 is can be used.
Leo 1.x and 2.0 can not be used.
But Leo 2.0 can be updated to Leo 2.1.
The AcuLaser C1000 CD-ROM will contain Leo updating firmware (from
Leo 2.0 to Leo 2.1).
For network printing, additional 32MB RAM is needed (recommended).
In the case of network printing, the printer must be capable of spool for all
data on one page before starting to print. Therefore, addition of 32 MB or
more memory to the printer is recommend.

1.7.4 Other Information (Only for AcuLaser C1000)

• The Network Status Sheet of Leo can be printed.
• Support of MAC OS X is TBD.
Revision E
60