Ethernet Interface Specifications (Only For Aculaser C2000); Usb Interface Specifications (Only For Aculaser C1000) - Epson ACULASER COLOR 2000 Service Manual

EPSON AcuLaser C2000 / AcuLaser C1000
1.3.2 Ethernet Interface Specifications
(Only for AcuLaser C2000)
Interface Types:
10Base T, 100Base TX, Half Duplex, Full Duplex: auto switching when the
power is turned On.
Communication Protocols
IPX/SPX (IPX, SPX, NCP, RIP, SAP, PrintServer, RemotePrinter,
NDS, SNMP, ENPC)
NetBIOS (SMB)
NetBEUI
TCP/IP (IP, UDP, Port9100, TCP, LPR, FTP, TELNET, ARP, ICMP,
RARP, BOOTP, DHCP, HTTP, IPP, SNMP, ENPC)
AppleTalk (ELAP, DDP, ATP, PAP, AARP, NBP, ZIP, RTMP, SNMP,
ENPC)
ENPC: EPSON Network Peripheral Control Protocol
IPP: Internet printing protocol
Connector Name RJ45
Compatible Cable 2-pair STP (10Base T, 100Base TX)
In order to conform to FCC Class B, EN55022 Class B and VCCI Class B, a
shielded type cable should be used.
Table 1-27. Pin Arrangement
Signal
Pin I/O
Name
1 Tx+ O
2 Tx- O
3 Rx+ I
4 N.C. -
Entity Type : See Type B interface specifications.
Product Descriptions
Signal
Pin I/O
Name
5 N.C. -
6 Rx- I
7 N.C. -
8 N.C. -
Interface Specifications
1.3.3 USB Interface Specifications
(Only for AcuLaser C1000)
The USB interface is compliant with the Universal Serial Bus Specification Rev.
1.1.
This printer indicates 18-digit USB serial numbers. Each digit denotes the
information as described below.
1, 2 : Number from 00 to 99 specific to model (06 for AcuLaser C1000)
3 : P for page printer
4, 5 : PC number on the assembly belt
6, 7 : Year of assembly
8, 9 : Month of assembly
10, 11 : Day of assembly
12, 13 : Hour of assembly
14, 15 : Minute of assembly
16, 17 : Second of assembly
18 : Reserved digit (0 is normally specified)
The specified USB serial numbers are confirmed in the Status Sheet. The
numbers are displayed on the bottom left of the Status Sheet, next to the ROM
version.
If the circuit board is replaced for maintenance services or
C A U T I O N
some other reason, the USB serial number must be
changed to another USB ID. Consequently, a computer
connected to the repaired printer recognizes the printer as a
different one, requiring the printer to reinstall a USB port
driver.
Revision E
36