Details Of Error Messages And Remedies; Details Of Error Messages And Remedy (Aculaser C2000) - Epson ACULASER COLOR 2000 Service Manual

EPSON AcuLaser C2000 / AcuLaser C1000

3.2.3 Details of Error Messages and Remedies

Below are the error messages that are unique to AcuLaser C2000 / AcuLaser
C1000.
3.2.3.1 Details of Error Messages and Remedy
(AcuLaser C2000)
Check Media Type
Explanation
A paper which is not correct OHP sheet is fed. Or printed on OHP
sheets although OHP has not been selected.
Does not print and eject the sheet. When duplex is selected, sheet
remains in the Duplex unit and paper jam occurs.
LED
The On Line LED is off and Continue LED is on.
Treatment Method
1) Set correct sheet to the paper feeder.
Press the Continue switch to release the error.
2) Execute Reset or Warmboot.
Install Photocondctr
Explanation
The Photoconductor Unit is not set. Or it is not set correctly.
LED
The On Line LED and Continue LED are off.
Treatment Method
Open the Front cover. Remove the Waste Toner Collector if it is set
then reinstall the Photoconductor unit correctly. Reset the Waste Toner
Collector then close the Front cover, and the error will released
automatically.
Install Waste T Box
Explanation
A Waste Toner Collector is not set. Or it is not set correctly.
LED
The On Line LED and Continue LED are off.
Troubleshooting
Treatment Method
Open the Front cover, set a Waste Toner Collector, then close the
cover. The error will be canceled automatically.
Install Oil Roll
Explanation
The Fuser Oil Roll is not set. Or it is not set correctly.
LED
The On Line LED and Continue LED are off.
Treatment Method
Open the cover-A, set a Fuser Oil Roll, then close the cover-A. The
error will be canceled automatically.
Install Fuser
Explanation
The Fuser unit is not set. Or it is not set correctly.
LED
The On Line LED and Continue LED are off.
Treatment Method
Open the cover-A, remove the Fuser Oil Roll if it is set. Set a Fuser
unit, then set the Fuser Oil Roll again. Close the cover-A and the error
will be canceled automatically.
Install TransferBelt
Explanation
The Transfer Belt unit is not set.
LED
The On Line LED and Continue LED are off.
Treatment Method
Open the Front cover, remove the Waste Toner Collector and the
Photoconductor Unit if they are set. Set a Transfer Belt Unit and reset
the Photoconductor Unit and the Waste Toner Collector. Close the
Front cover and the error will be canceled automatically.
Printer Message
Revision E
114