Epson ACULASER COLOR 2000 Service Manual page 115

EPSON AcuLaser C2000 / AcuLaser C1000
Clean Sensor
Explanation
The window of sensor for engine calibration is soiled.
LED
The On Line LED and Continue LED are off.
Treatment Method
Open Front Cover and remove Waste Toner Collector. Turn the green
lever (at left side o the center) upward then put it back. Reinstall Waste
Toner Collector then close Front Cover.
uuuu Toner Out
Explanation
It is detected that there is no toner remaining by the toner end sensor
for each color. If it is canceled temporarily by pressing the Continue
switch, this error will be produced in every page printed.
When Toner Out = Continue, this error is not produced. u u u u
indicates C, M, Y, K toner cartridge, which correspond to the C, M, Y
and K toner cartridges, and out of these, those toner cartridges only
where it is detected that there is no toner remaining are displayed.
LED
The On Line LED is off and Continue LED is on.
(This specification is different from that of AcuLaser C8500.)
Treatment Method
1) Replace toner Cartridge.
Open the Front cover, replace empty toner cartridge with new one.
Close all covers and the error will be canceled automatically.
Toner Counter is reset automatically.
2) Press the Continue switch to cancel the error temporarily.
Troubleshooting
Replace Photocondctr
Explanation
It is regarded that the photoconductor service life is end, based on the
total number of revolution of the photoconductor up to now from
previous replacement. And printing is stopped.
LED
The On Line LED and Continue LED are off.
Treatment Method
Open the Front Cover and replace Waste Toner Collector, Photo
conductor Unit and Print Head Filter with new ones.
Close the Front cover and the error will be canceled automatically. The
photoconductor counter is reset automatically and the panel display
"Photoconductor" in Setup Menu becomes 100%.
Replace Waste T Box
Explanation
The waste toner box has been sensed to be full of waste toner from the
engine, and printing is stopped.
LED
The On Line LED and Continue LED are off.
Treatment Method
Open the Front cover, then replace the Waste Toner Collector with
new one. Close the Front cover. The error will be canceled
automatically.
Replace Fuser
Explanation
It is regarded that the Fuser Unit service life is end, based on the total
number of revolution of the Fuser Unit up to now from previous
replacement. And printing is stopped.
LED
The On Line LED and Continue LED are off.
Treatment Method
Open the Cover-A and remove the Fuser Oil Roll, then replace the
Fuser Unit with new one. Reset the Fuser Oil Roll. Then open the
Cover-B and replace the 2nd Transfer Roll.
Printer Message
Revision E
115