Table of Contents
Advertisement
10. Install a 5/16" x 3-1/2" eyebolt on top of both
the right and left side belting hangers using a
5/16" standard nut (X) and flat washer on top
and a 5/16" lock nut (Y) and flat washer under-
neath. Orient the eyebolts as shown below
and torque the lock nuts to 135 in-lbs (15 Nm).
Check to ensure that approximately one thread
of the eyebolt is through the nylon lock nut.
X
Y
11.
Fasten the clip on the supplied polymer bungee
strap to the left eyebolt and hook the opposite
end onto the right eyebolt.
SPREADER SETUP & INSTALL KITS
X
Y
12. The drop curtain belting will need to be cut to fit
over the gate cable. Drill a 13/32" hole through
the left side of the drop curtain belting at the
bottom of the V-notch in the side drop curtain
mounts. Cut the drop curtain from the hole to the
top edge of the curtain belting.
13. Rotate each side of the drop curtain up into
place with one of the side curtain mounts on
each side of the side belting hanger flange until
the mounting holes are aligned.
14. Fasten each side in place with a 3/8" x 3/4" ball pin.
15. Insert the gate cable through the slit and into the
hole in the drop curtain.
16.
Installation is complete. NOTE: not all parts
in this kit will be used in all applications.
Setup - 30
Advertisement
Table of Contents
