Table of Contents
Advertisement
SS575 Drop Curtain Kit
Before making repairs or adjustments set the parking
brake, turn off engine, and remove ignition key.
Always disconnect the negative battery cable from the
battery when working with electrical components. Always
work in a manner that does not put safety at risk!
Installation Time (estimated)
Tools Required:
9/16" wrench & socket
Attention
To prevent thread galling, hand tools and a thread
lubricant are recommended when tightening stain-
less steel fasteners. Do not use air or electric power
tools as this increases the potential of thread galling.
Drop Curtain Setup
1. On both ends of the drop curtain, install a side
drop curtain mount (A) on each side of the belting
and fasten with 3) 1/4" x 3/4" bolts, 6) 1/4" flat
washers, and 3) 1/4" lock nuts as shown below.
Torque to 75 in-lbs (8.5 Nm).
A
A
SPREADER SETUP & INSTALL KITS
7/16" wrench & socket
utility knife (SS575)
Safety glasses must be worn during installation.
Ear (hearing) protection must be worn when
Installation Notes: Right and left hand orienta-
tion referred to in these instructions is determined
as if sitting on the tractor seat, facing forwards.
30 minutes
drill (SS575)
2. Install the curtain clamp bracket (B) on the
outside (smooth side) of the drop curtain and the
rear belting mount (C) on the inside of the drop
curtain. Install 2) 1/4" x 3/4" bolts, 4) 1/4" flat
washers, and 2) 1/4" lock nuts in the two outside
holes only. Torque to 75 in-lbs (8.5 Nm).
Setup - 27
using air or power tools.
1/2" wrench & socket
13/32" drill bit (SS575)
C
ratchet
B
Advertisement
Table of Contents
