Table of Contents
Advertisement
Vibrator Installation
(Power Unit without Cab)
1. Install the switch on the controller bracket as
directed by the vibrator kit instructions.
2. Install the vibrator unit on the spreader hopper
as directed by the vibrator kit instructions.
3. Connect the vibrator wire harness to the switch
and route wire harness along the same path as
the spreader wire harnesses.
4. Connect the wire harness plug to the plug on the
vibrator unit.
5. Cut the terminals off the end of the battery har-
ness and strip 1/4" of insulation off the end of
each wire.
6. In the power unit's seat box area, locate the
adapter harness plug with white and black wires.
Insert the red wire from the battery harness into
the butt connector on the white wire (A) from the
adapter harness and crimp in place. Insert the
black wire from the battery harness into the butt
connector on the black wire (B) from the adapter
harness and crimp in place.
B
A
7.
Slide the heat shrink tube (C) over the butt con-
nectors and use a heat gun to shrink in place.
8. Loosen the Velcro ties that fasten the spreader
harness in place, include the vibrator harness,
and retighten the Velcro ties.
9. Loosen the Velcro ties that fasten the coils of
spreader wire, coil up any excess vibrator wire at
these points, and reinstall the Velcro ties.
SPREADER SETUP & INSTALL KITS
C
Vibrator Installation
(Power Unit with KW450 Cab)
1. Install the switch on the controller bracket as
directed by the vibrator kit instructions.
2. Install the vibrator unit on the spreader hopper
as directed by the vibrator kit instructions.
3. Connect the vibrator wire harness to the switch
and route wire harness along the same path as
the spreader wire harnesses. Route the vibrator
wire harness through the grommet in the mount
support and the cushioned metal clamp under
the foot platform that contain the spreader wire
harnesses.
4. Connect the wire harness plug to the plug on the
vibrator unit.
5. Cut the terminals off the end of the battery har-
ness and strip 1/4" of insulation off the end of
each wire.
6. In the power unit's seat box area, locate the
adapter harness plug with white and black wires.
Insert the red wire from the battery harness into
the butt connector on the white wire (A) from the
adapter harness and crimp in place. Insert the
black wire from the battery harness into the butt
connector on the black wire (B) from the adapter
harness and crimp in place.
7.
Slide the heat shrink tube (C) over the butt con-
nectors and use a heat gun to shrink in place.
8. Loosen the Velcro ties that fasten the spreader
harness in place, include the vibrator harness,
and retighten the Velcro ties.
9. Loosen the Velcro ties that fasten the coils of
spreader wire, coil up any excess vibrator wire at
these points, and reinstall the Velcro ties.
Setup - 26
C
B
A
Advertisement
Table of Contents
