Table of Contents
Advertisement
23. Locate the adapter harness plug with red and
black wires. Insert the red wire from the battery/
controller harness into the butt connector on the
red wire (K) from the adapter harness and crimp
in place. Insert the black wire from the battery/
controller harness into the butt connector on
the black wire (L) from the adapter harness and
crimp in place.
K
L
24.
Slide the heat shrink tube (M) over the butt con-
nectors and use a heat gun to shrink in place.
25. If the spreader is being used without a vibrator,
fold the white and black wire with butt connec-
tors back along the connector and harness and
tape in place.
26. Coil the extra wire of the battery/controller har-
ness inside the seat box area and use a Velcro
tie to fasten the coils together.
27. Install the 25 amp circuit breaker into slot 1 of
the rear fuse panel and the 10 amp fuse into slot
3 of the rear fuse panel.
SPREADER SETUP & INSTALL KITS
M
28. Remove the cover from the power relay module
and replace both J-case fuses (P) with the sup-
plied 60 amp J-case fuses.
29.
Connect the negative battery cable to the battery.
30. Use the #10-32 x 1-1/2" screw and flange nut to
attach the tether on the spreader's power cord
cap to the plug on the power cord.
31. Check the gate cable to ensure it does contact
sharp edges or moving parts. Use Velcro ties to
fasten away from sharp edges or moving parts.
Installation is complete.
Setup - 25
P
Advertisement
Table of Contents
