Table of Contents
Advertisement
9. Place the harnesses into the cushioned metal
clamp, install the second flange onto the bolt,
and fasten with a 1/4" flange nut.
10. Route the harnesses up over
the front of the foot platform
and up along the cab post.
11. Connect the wire harnesses
to the connectors on the back
of the spreader controller.
12. Fasten the harnesses to the
cab post at 2) places using
Velcro ties.
13. Pull any slack in the har-
nesses back up through the
seat box frame.
14.
Route the gate control cable in
front of the spreader,
forward between the
rear hitch and the right
wheel above the axle,
and then follow the
spreader wire har-
nesses under the foot
platform and up along
the cab post. Install the
gate control cable and
handle (H) onto the gate cable mount bracket.
15. Fasten the gate cable to the cushioned metal
clamp under the foot platform using a Velcro tie.
16.
If gate cable is already mounted to the spreader,
Pull the gate cable handle out
skip to step # 20.
3" and determine the length of cable needed to
reach the gate body. NOTE: before cutting the
cable to length, check to ensure that there is
enough slack in the cable to allow the control
cable to slide freely in the cable housing.
17. Cut off the cable at the desired length and then
push the gate cable handle back into the cable
housing. Slide the brass cable fitting onto the
gate cable and thread onto the cable housing.
SPREADER SETUP & INSTALL KITS
18.
Install the cable fitting onto the gate body (I) as
shown.
19. Insert the cable
end into the
gate slide
(J) and
through
the hole in the bolt. Ensure
the gate slide is in the closed
position and tighten the bolt to
secure the gate cable.
20. Route the motor/controller
harness down through the
seat box frame behind the rear hydraulic motor
and out through the rear hitch.
21. Connect the motor/controller harness to the plug on
the spreader, coil up the extra wire in the rear hitch
area, and fasten the coils together with a Velcro tie.
H
22. Cut the push-on connectors off the end of the
battery/controller wire harness and strip 1/4" of
insulation off the end of each wire.
Setup - 24
I
I
J
J
Advertisement
Table of Contents
